Set Top of Form on a 2380, 2381

*IMPORTANT

Failure to follow these steps exactly as written will make aligning this printer extremely difficult if not impossible.

[back to top]

Set Top of Form

1. Tear off any excess paper in the back of the printer
2. On the front of the printer, press Alt + Park/Load to retract the forms. The Paper Out light should blink.
3. Press Alt + Park/Load again to advance the forms. The ready light should blink.
   *The top edge of the form should be even with the top edge of the silver metal strike plate.
4. Press the Micro Up/Down button to move the form into position.
5. Press Start/Stop to save.

[back to top]

IBS Lumber and Building Material Software Copyright © 2006 IBS Lumber Software Inc (TM)
Last modified: November 7, 2011

IBS Sales & Support 888-640-1252
Main Office 888-640-1252
Fax IBS 877-712-8937

All pages contained in this support website are not intended for general public distribution. Any material here can be considered private, confidential with various copyrights and restrictions against public release. You 'the browser' cannot legally release this information for general public distribution.

remote support: http://www.gotomeeting.com | remote support download program