IBM Server Site

IBS Home Up

Cleaning the tape drive

IBM Site link http://publib.boulder.ibm.com/infocenter/systems/scope/hw/index.jsp?topic=/iphcd/fc6258.htm

You might need to clean your tape drive. Use the procedure in this section to perform this task.
Clean the device whenever the Fault status light comes on or a system I/O error related to the device occurs.
Attention: Use only the recommended cleaning cartridge to clean the tape drive. Use of other than recommended cleaning cartridges can damage your drive and might void the warranty.
To clean the tape drive, complete the following steps:
  1. Make sure that the power is on to the tape drive.
  2. If a tape cartridge is in the tape drive, eject and remove the cartridge.
    Note: Some cleaning cartridges have white dots on the window side that are designed to be used to log the use of the cartridge. Each time the cartridge is used, mark one of the dots on the cartridge with a pen or marker. When all of the dots have been marked, discard the cleaning cartridge.
  3. Grasp the cleaning cartridge by the outer edges, with the window-side up and the write-protect switch facing you.
  4. Slide the cartridge into the opening on the front of the drive until the loading mechanism pulls the cartridge into the drive and the drive door closes.
After the cleaning cartridge has been inserted, the remainder of the cleaning process is automatic. The tape drive does the following:
  • Loads the cleaning cartridge into the tape drive.
  • Cleans the drive by moving the cleaning tape forward for approximately 30 seconds.
  • Unloads the cleaning cartridge when the cleaning operation is complete.
  • Indicates a successful cleaning operation by turning off the Fault status light (if the Fault light was on prior to the cleaning process.
    Note: If the cleaning operation completes but the Fault light remains on, repeat the cleaning procedure with a new cleaning cartridge. If the light still remains on, contact your authorized service provider.

To determine how many times a cleaning cartridge can be used, check the information printed on the cartridge. If you attempt to use a depleted cleaning cartridge, the tape drive automatically detects the error and ejects the cartridge. If the Fault status light was on prior to the cleaning process, it stays on; if the Fault light was off, the depleted cartridge causes the light to come on.

If a system error occurs, clean the drive and retry the operation. If the operation fails, replace the data cartridge, clean the drive again, then retry the operation.

[back to top]

IBS Lumber and Building Material Software Copyright © 2006 IBS Lumber Software Inc (TM)
Last modified: November 7, 2011

IBS Sales & Support 888-640-1252
Main Office 888-640-1252
Fax IBS 877-712-8937

All pages contained in this support website are not intended for general public distribution. Any material here can be considered private, confidential with various copyrights and restrictions against public release. You 'the browser' cannot legally release this information for general public distribution.

remote support: http://www.gotomeeting.com | remote support download program